Jet Pump Do's and Don'ts

Don't	Run pump dry (without water).
Do	Fill pump and plumbing with water before startup.
Do	Make certain all valves and nozzles on both the inlet and outlet side of the pump are open while the pump is in operation.
Do	Install pressure relief valve.
Don't	Pump water which contains sand, mud, silt, or debris.
Don't	Pump oil, petroleum products, chemicals, cleaning agents or viscous liquids
Do	Ground motor, do not ground to gas supply line.
Do	Wire motor to correct supply voltage - see motor nameplate and wiring diagrams and check voltage of power supply.

Home	Products	Where to Buy	Featured Products
Contact Us	Literature	Troubleshooting	FAQ's